SPECIFICATIONS

DIMENSIONS (HWD)

• 1 3/4" x 19" x 12 1/2" (4.5 cm x 44 cm x 32 cm)
• RU: 1

WEIGHT
8.8 lbs (4 kg)

POWER
90-264v AC140 W (3 PIN IEC)

FRONT PANEL COMPONENTS

• IR Sensor: Infrared receiver port (IRRX) for learning IR remote control functions from IR controlled devices
• Outputs: 16 RJ-45 ports for connection with compatible UDM-RX02 Receivers
• A/V Inputs: 4 RJ-45 ports for connection from Endeleo TVM hubs (via Cat5, Cat5e or Cat6)

REAR PANEL COMPONENTS

• Network Port: RJ-12 10baseT network port provides network connectivity
• Serial Port: RJ-12 port allows an administrator to control various functions from a command line prompt
• IRTX Ports: 2 Infrared Transmit (IRTX) ports allow the UDM Hub to control IR devices via IR emitters attached to the UDM. The IR cable is attached to the IR panel of the controlled device to receive IR commands issued through the software or remote control.
• Input Connectors (A-D): 4 sets of Input connections for up to 4 A/V inputs with the following connectors:
  - Video
  - Audio Left
  - Audio Right
  - S/PDIF
• Cascade IN/OUT Ports: These ports allow UDM Hubs to be cascaded together.
• Cascade In Port (from another UDM Hub)
• Cascade Out Port (to another UDM Hub)
• IEC Power Connector: Universal switch-mode power supply.
  - As a Class 1 appliance the Hub should be connected to a mains supply with a protective earthing connection.
  - The Power On/Off switch is located beside the IEC power connector.
  
  Note: The rating label found to the bottom left of the hub, beneath the IEC connector, contains important information applicable to the Hub's installation environment.

NETWORK INTERFACE
10baseT

SERIAL INTERFACE
9600,8,N,1

MAX VIDEO INPUT

• 4 x RGBHV (or)
• 4 x S-Video (or)
• 12 x Composite (plus)
• 4 x Endeleo TVM-1600 or CVBS

CASCADE PORT
Matrix connector for tertiary units

ELECTRICAL
RJ-45 indicating power to receiver and link status

CERTIFICATIONSCE,UL,FCC part 15 Class A

ENVIRONMENTAL

• 35ºF to 95ºF (5ºC to 35ºC)
• Max. relative humidity - 85% (non-condensing)

INCLUDED ACCESSORIES

• IEC power cord
• 19" mounting brackets
• RS-232 DB-9/RJ-12 connection cable (FG-RS01)
• 6' Ethernet Crossover Cable
• IR03 External Infrared Receiver Module (FG-IR03)
• UDM-RC10 IR Engineering Remote Control (FG-UDM-RC10)
• NOTE: No A/V interface cables supplied

Learn important installation, configuration and programming techniques in the following course(s) from AMX University:

• Signal Management Essentials (Online)
• Getting Started with Endeleo Products (Online)
• Endeleo System Configuration (Online)
• Signal Management Design

For schedules and registration for these and any AMX University courses, visit www.amx.com/training.